Sulky Vision Can WPB Manual de usuario descargar pdf (Pagina 99)

b) menu.

- 1 - Select the menu.

- 2 - Select the PAR/TOT menu.

- 3 - Reset each counter to zero using the RAZ function

- 4 - As soon as the alarm goes o and the bell is displayed on the screen, select to nd out the reasons.

- Select OK to return to the main screen.

- 5 - Select if you wish to save your work.

Stop & Go Version

a) menu

- 1 - Select the menu.

- 2 - Check that all the parameters have been saved correctly: speed sensor and working width .

- 3 - Select your correction mode .

- 4 - Select TARE and set it to zero.

- 5 - Select your fertiliser .

notE

You can now ll the hopper of the fertiliser spreader.

c) menu.

- 1 - Select the menu.

- 2 - Check: • that the fertiliser selected is correct,

• that the electric shutters are well closed,

• that your correction mode is correct (Dynamic or Static).

- 3 - Select your application rate per hectare:

- use the numeric keypad directly, validate with .

- 4 - Go to spreading and select the Test or Auto correction.

- 5 - Your spreading is DPA.

You can adjust your dose/hectare: select or then return to initial rate selecting .

- 6 - You may adjust either the right side selecting or the left side selecting .

- 7 - You may enable the 3D Tribord.

notE

For using the automatic mode with the guidance bar, refer to the “Stop&Go” quick start-up instructions.

Start-up

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 134 135

Sin comentarios

Sulky Vision Can WPB Manual de usuario Pagina 99